Volkswagen cars basically work similarly, very few cars need a computer to restart, under normal circumstances, only older 7 does not have an LCD central control panel, there is also a B8 LCD instrument, but there is no button in middle of instrument, and there is a special ODIS Directly login to instrument and use function manual to reset I will explain method to directly enter instrument to change data without a special computer.
Select Tool Login
Choose matching 10 channels
These two options are entered separately to change time and mileage of oil changes and maintenance. For example, if a customer uses full synthetic motor oil and needs to change it for 10,000 kilometers, he can enter 10,000 immediately and save it after entering, and time will be same.
These two data are data for checking condition of car. After entering this data, you can enter 0, which means that it will be used after maintenance.
Notes: The change data method can be used on vehicles that have failed maintenance and reset, and older models are not in this range.
There is also a special oil level alarm.
We see this alarm often and it's no use resetting it, it's actually because machine has started to check that fluid level is low enough to remind you to check, but computer hasn't detected your Add Oil Action Standard Operating Procedure: turn off engine, turn off ignition for 5 seconds, open door and open hood (within 30 seconds after 5 seconds), close hood 30 seconds after opening hood. (this time interval is recommended to be 5 minutes, if you close it too early, it is easy to be out of order), and then start car to observe. Alarm hint has been removed.
Also, reminder will be removed after driving 100 km (after topping up oil)
Notes: Skoda has such a hint that this operation is useless, and Skoda needs to use a special computer to enter engine system function manual to perform learning value elimination operation.